Stamps – Little Posy Basket stamp set
Papers –
Cream card stock half-sheet, folded
Purple designer paper strip – about 5.5 x 1.25 inches
Black card stock scraps
Moss Green designer paper (for larger label)
Off-white card stock (for top label)
Off-white card stock scrap
Inks – Versacolor Bark, Bamboo, Peony, Neptune
Accessories -
Spellbinders Dies (Labels Four - S4-190)
Cuttlebug embossing envelope – D'Vine Swirls and Textile Textures
Embellishments -
Ribbons
Gold Paint Pen
Adhesive Pearls – Black
Instructions -
Run the front of the Cream card stock half-sheet through the D'Vine Swirls embossing envelope. Set aside for a moment. Run the Purple scrap through the Textile Textures embossing envelope. Then edge with the Gold Paint Pen. When the gold paint dries, glue the strip to a piece of slightly larger Black card stock. Trim away the excess, leaving a thin pinstripe of Black. Glue this strip to the card base. Then glue the ribbon on top of the Purple strip and set the card base aside.
Run the Moss Green paper through the machine using the second largest die in the set. Then emboss the resulting label with the Textile Textures embossing envelope. Edge using the Gold Paint Pen and once the paint has dried, glue to a slightly larger piece of Black card stock and trim away the excess like you did for the Purple strip. Glue to the card base, over the Purple strip.
Locate the Off-white card stock run it through the machine using the third largest die in the set.
Stamp the following:
Basket in Bark
Flowers in Peony and then again in Neptune.
Sprig in Bamboo (this sample uses the Sprig as part of the basket arrangement and as grass)
Then stamp around the border using the Flowers stamp and Peony and Neptune ink.
Edge the label with Bark ink. Then glue to a slightly larger piece of Black card stock and trim away the excess like you did two other times. Glue this piece on top of the Moss Green label created earlier.
The next step is to make the decorative element that will be attached under the label. Simply cut a thin strip of Off-white card stock, cut an angle at each end, edge it with the Gold Paint Pen, and then glue to the card base. The last step is to attach the Adhesive Pearls.
|
|
