Stamps - Easter Egg Border stamp set "Especially for You" block stamp
Papers - Rose card stock half-sheet, folded Yellow/Green designer paper Dark Green card stock White card stock - 3.25 x 4.25 Designer Paper - Pink and White Floral print - 1.25 x 2.25 inches Designer Paper - Pink and White Stripes - 5/8 inch x 4.25 inches
Inks - Versacolor Old Rose, Split Pea, Burgundy, Green Tea, Evergreen, Pinecone, Khaki
Embellishments - Dark Brown Brad Gelly Roll Stardust Pen Chalk - Sage Green Burgundy Ribbon
INSTRUCTIONS - Run the Rose card-base through the embossing folder and set aside.
On the White card stock, stamp a border in the following stamps and inks:
Mini Floral Egg - Old Rose and then again in Khaki
Tiny Faberge Egg - Green Tea
Dogwood Flower - Burgundy
Dogwood Leaves - Evergreen
Grass Blades - Pinecone
Once you have finished stamping, use the Sage Chalk around the edges for added dimension. Then glue the stamped card stock to the Dark Green paper and then glue the resulting piece to the Yellow-Green designer paper. Glue the resulting layered piece to the card base.
EMBELLISHMENTS -
MAKE THE TAG Take the Pink and White Floral designer paper and clip two corners to form a tag. Next, stamp "Especially for You" in Pinecone ink in the center of the paper. Then stamp the following around the border:
Mini Floral Egg in Old Rose ink
Dogwood Leaves in Khaki ink.
Edge the tag using the Khaki ink. Glue a slightly larger piece of Dark Green card stock behind the tag. Next, punch a hole in the end of the tag and then add the Brad and Ribbon. Set aside momentarily.
MAKE FLORAL CUT-OUTS
On a small scrap of White paper, stamp a series of Dogwood images in Burgundy ink. Then add some Leaves in Green Tea ink. Trim around the stamped images and use PopIt! Shapes to attach the cut-out to the Striped Paper strip. Use Copper Brads to attach the paper and the Burgundy Ribbon to the card base. Then slip the tag you just made behind the embellished strip.
Stamp some assorted images in various inks and cut them out. Arrange the cut-outs on top of the tag and at the bottom of the finished card.
Use the Gelly Roll Pen to add some sparkle around the cut-outs and the edge of the main panel of the card base and that's it!
