Brown designer paper - 8.5 x 4 inches, folded to open horizontallyPea Green card stock - 4.25 x 1.25 inchesWhite card stock - 2.5 x 2-5/16 inchesRose designer paper - 2-5/8 x 2-7/16 inchesWhite card stock scraps
Inks (Versacolor)
Green TeaSplit PeaBark
Tools and Embellishments
Chalk - ButterscotchCuttlebug embossing folder - "Swiss Dots"Colored Pencil - BrownGold Paint PenRibbonRound die - approximately 1.5 inch in diameter
Instructions
Take the Split Pea paper and run it through the embossing folder. Then scuff it a bit with Split Pea ink. Before the ink is dry, use the Butterscotch Chalk on a Chalk Puff and scuff some of the raised areas of the embossed paper. Then glue the ribbon to this strip and glue the strip to the card base. Set aside for now.Take the White pre-measured card stock and stamp the Fescue Sprig in Green Tea to form a rectangular pattern. Then use the Brown Colored Pencil to add just a touch of color to the corners and inside edges of this panel. Next, use the Gold Paint Pen to edge the paper. Glue to the pre-measured Rose designer paper and glue the resulting ensemble to the card base, on top of the ribbon you fastened down earlier.
On a White card stock scrap, stamp the Fescue Sprig in a radiating pattern in Split Pea ink. Then center the stamped piece in the Round Die and cut out. Next, color the outer edges with the Brown Colored Pencil like you did on the rectangular panel earlier. Edge with the Gold Paint Pen and mount with PopIt! Shapes tape to the card base, on top of the panel you stamped earlier.
Last, on another White scrap, stamp the Fescue Sprig in radiating pattern, this time using Bark ink. Then cut the star-shaped figure out and glue it on top of Split Pea version you made earlier. That's it! Finished!
